Secured with TLS · Sessions expire after 30 min
This is a one-time setup. Set your admin password and confirm your system tokens.
You can change these later in Settings.
Add lights to each preset and set their state. Tapping a preset button applies all its lights at once.
The relay/coil for this zone's heating valve.
For a zone with two valves — this relay opens/closes together with the first.
Which underfloor-heating pump serves this zone. The pump runs whenever any of its zones calls for heat.
Displays the room's humidity on its climate card (needs a humidity sensor for the room).
What your sensor board calls this room (the bit before _temp/_humidity). Comma-separate if several. Leave blank to use the zone id.
Connect your Hildebrand/Glow account to show today's electricity and gas usage and cost. Your login is stored only on this box and never leaves it.
± minutes randomises each light's times daily so the house looks occupied. Brightness applies to dimmers.
Blank = disabled. Overnight periods (e.g. 22:00–06:00) are supported.
When something happens, do something — for example, when a switch is pressed, turn on a light.
Admin actions (hardware setup, firmware updates, settings) are protected by a PIN.
Admin unlocked for this session.
No admin PIN is set yet. Create one to protect admin actions on this box.
| Username | Role | Last login |
|---|
RS-485 dimmer and LED boards self-report on discovery. Tap Identify to flash a board's onboard LED, then name it and map its channels to lights.
Keeps the app (dashboard and controller software) up to date. Updates are verified and can roll back automatically if there's a problem. Applying requires the admin PIN.
Turn features on or off for this system. Hidden tabs stay off across all devices. Configured on-site.
Add cameras, set zones, doorbell and face recognition.
For bench development without hardware. When on, a full set of fake sensors is added so gauges and dropdowns behave as if everything were connected. Turn off before shipping.
The system checks for device firmware updates monthly when online. Updates are never applied automatically — you choose when and what to update. Applying is only available on the local (onboard) panel.
Upload a .bin directly to this box for a device type, for one-off testing without a central release. Applying happens from the update list above once uploaded.
Link this box to your cloud account to control it when you're away. Tap below to get a pairing code, then enter it in your account at the remote site.
✓ This box is linked to a cloud account (). Remote access is enabled.
Link a box to your account. On the box's onboard screen, tap "Connect to cloud" to get a pairing code, then enter it here.